Material Safety Data Sheet
1. Chemical Product and Company Identification
DESCRIPTION: ELMER'S CARPENTERS WOOD GLUE PRODUCT TYPE: PVAC BASED ADHESIVE APPLICATION: FOR PRODUCT CODES SEE SECTION 16
· Manufacturer/Supplier Information
MSDS Prepared by: Elmer's Products, Inc. Emergency Phone Number 1 Easton Oval Poison Control Center Columbus, OH 43219 888-516-2502 For additional health, safety or regulatory information, call 888-435-6377 Call 1-800-848-9400 to place an order or request additional MSDSs.
2. Composition, Information on Ingredients
No hazardous ingredients known to company.
3. Hazards Identification
3.1 Emergency Overview
Appearance Light yellow liquid Odor Mild acetic aroma Not an immediate health hazard.
· HMIS Rating
HEALTH = 0 (minimal) FLAMMABILITY = 0 (minimal) REACTIVITY = 0 (minimal)
3.2 Potential Health Effects
· Immediate Hazards
INGESTION: No hazards known to company. INHALATION: No hazards known to company. SKIN: No hazards known to company. EYES: No hazards known to company.
· Delayed Hazards
None of the components present in this product at concentrations equal to or greater than 0.1% have been listed by NTP, classified by IARC, nor regulated by OSHA as a carcinogen.
4. First Aid Measures
INGESTION: If accidentally swallowed, dilute by drinking large quantities of water. Immediately contact poison control center or hospital emergency room for any other additional treatment directions. EYES: Immediately flush eyes with plenty of water. Call a physician if irritation persists.
5. Fire Fighting Measures
Autoignition Temperature Not available Upper/Lower Flammable Limits Not applicable Up/Lower Explosive Limits, % by Vol Not applicable Flash Point Not applicable Will not burn unless water has evaporated. Dried material may burn. In case of fire, water should be used to keep fire-exposed containers cool.
6. Accidental Release Measures
Soak up with absorbent material and remove to a chemical disposal area. Prevent entry into natural bodies of water.
7. Handling and Storage
7.1 Handling
Handle in accordance with good industrial hygiene and safety practices.
7.2 Storage
Keep from freezing. Store in a cool, dry place. Keep containers tightly closed.
8. Exposure Controls/Personal Protection
8.1 Exposure Controls
No special control measures necessary under normal conditions of use.
8.2 Personal Protection
No special protection necessary.
8.3 Exposure Guidelines
None established
9. Physical and Chemical Properties
Percent Volatiles 54.5 pH @ 25 C 5.0 Specific Gravity 1.08 Appearance Light yellow liquid Autoignition Temperature Not available Boiling Point 100°C (212°F) Vapor Density (Air=1) <1 Vapor Pressure, mm Hg @ 20 C 17.5 Evaporation Rate (Butyl Acetate=1) <1 Upper/Lower Flammable Limits Not applicable Up/Lower Explosive Limits, % by Vol Not applicable Flash Point Not applicable Freezing Point 0°C (32°F) Odor Mild acetic aroma Odor Threshold, ppm Not available Solubility in Water Dispersible Coefficient of Water/Oil Distrib. Not available
10. Stability and Reactivity
Normally stable as defined in NFPA 704-12(4-3.1).
· Incompatibilities:
Strong acids and alkaline materials.
· Decomposition products may include:
CO, CO2.
· Hazardous polymerization:
Will not occur.
· Other Hazards:
None known to company.
11. Toxicological Information
INGESTION: A similar product was found to be non-toxic orally when tested as described in 16 CFR Part 1500.3(c)(1) and (2). INHALATION: A similar product was found to be non-toxic by inhalation when tested as described in 16 CFR Part 1500.3 (c)(1) and (2). SKIN A similar product was found to be non-toxic dermally ABSORPTION: when tested as described in 16 CFR Part 1500.3 (c)(1) and (2). SKIN: A similar product was not an irritant when tested as described in 16 CFR Part 1500.41. EYES: A similar product was not an irritant when tested as described in 16 CFR Part 1500.42.
12. Ecological Information
Not determined.
13. Disposal Considerations
Recover free liquid. Absorb residue and dispose of according to local, state/provincial, and federal requirements.
14. Transport Information
14.1 U.S. Department of Transportation (DOT)
The data provided in this section is for information only and may not be specific to your package size. You will need to apply the appropriate regulations to properly classify your shipment for transportation. Non-Regulated.
14.2 Canadian Transportation of Dangerous Goods (TDG)
Non-Regulated.
15. Regulatory Information (Selected Regulations)
15.1 U.S. Federal Regulations
· OSHA Hazard Communication Standard 29CFR1910.1200
This material is not a "health hazard" or a "physical hazard" as determined when reviewed according to the requirements of the Occupational Safety and Health Administration 29 CFR Part 1910.1200 "Hazard Communication" Standard.
· SARA Title III: Section 311/312
Does not meet any hazard category
· SARA Title III Section 313 and 40 CFR Part 372
This product contains the following toxic chemical(s) subject to the reporting requirements of Section 313 of Title III of the Superfund Amendments and Reauthorization Act of 1986, and Subpart C-Supplier Notification Requirement of 40 CFR Part 372. None required per SARA TITLE III SECTION 313.
· TSCA Section 8(b) Inventory
All reportable chemical substances are listed on the TSCA Inventory. We rely on certifications of compliance from our suppliers for chemical substances not manufactured by us.
15.2 Canadian Regulations
· Workplace Hazardous Materials Information System (WHMIS)
This product has been classified in accordance with the hazard criteria of the Controlled Products Regulation (CPR) and the MSDS contains all the information required by the CPR. Not a controlled product
· Canadian Environmental Protection Act (CEPA)
All reportable chemical substances are listed on the Domestic Substances List (DSL) or otherwise comply with CEPA new substance notification requirements.
· National Pollutant Release Inventory (NPRI)
This product contains the following chemical(s) subject to the reporting requirements of the Canadian Environmental Protection Act (CEPA) subsection 16(1), National Pollutant Release Inventory. None required.
16. Other Information
AP (Non-Toxic): Products bearing the AP (Non-Toxic) Product Seal of The Art & Creative Materials Institute, Inc. (ACMI) are certified in a program of toxicological evaluation by a medical expert to contain no materials in sufficient quantities to be toxic or injurious to humans or to cause acute or chronic health problems. This program is reviewed by ACMI's Toxicological Advisory Board. These products are certified by ACMI to be labeled in accordance with the chronic hazard labeling standard, ASTM D-4236 and Federal Law, P.L. 100-695. In addition, there is no physical hazard as defined within 29 CFR Part 1910.1200(c). MSDS covers items: U.S.: E614, E700, E701, E702, E704, E705, E706, E970, E980, E1367, E1825, E1850 Canada: 60613, 60614, 60615, 60616, 60617, 60618, 60619
· User's Responsibility
The OSHA Hazard Communication Standard 29CFR 1910.1200 and the Workplace Hazardous Materials Information System (WHMIS) require that the information contained on these sheets be made available to your workers. Educate and train your workers regarding OSHA and WHMIS precautions. Instruct your workers to handle this product properly. Consult with appropriate experts to guard against hazards associated with use of this product and its ingredients.
· Disclaimer
SELLER MAKES NO WARRANTY, EXPRESS OR IMPLIED, CONCERNING THE PRODUCT OR THE MERCHANTABILITY OR FITNESS THEREOF FOR ANY PURPOSE, except that the product shall conform to contracted specifications, and that the product does not infringe any valid United States or Canadian patent. No claim of any kind shall be greater in amount than the purchase price of the quantity of product in respect of which damages are claimed. In no event shall Seller be liable for incidental or consequential damages, whether Buyer's claim is based on contract, breach of warranty, negligence or otherwise. CURRENT ISSUE: 27-JUN-06 PREVIOUS ISSUE: 13-JAN-05
http://www.elmers.com/msds/me700_d.htm